IP Extender over Coax
IP Extender over Coax
IP Extender over Coax
IP Extender over Coax
IP Extender over Coax
IP Extender over Coax

IP Extender over Coax

Model: IP1
Our Price: Members Only
Hurry up! only left
Product Details

IP Extender over Coax

Our IP1 is a low cost, easy and quick solution that allows the use of a coaxial cable to send IP data between two network devices with an RJ45 connection. Use with your existing or new RG59 coaxial cable to exceed the IEEE 802.3 10BASE-T specification and a transmission range up to 656ft (200m) at 10Mbps speed.

  • Send IP data over existing coaxial cable
  • Exceeds 802.3 10BASE-T specifications, Isolation between transmitter and receiver
  • Transmission range up to 656ft (200m)
  • Passive, No Power Required
  • Plug n Play, Easy to install
  • Sold in pairs
Resources

IMPORTANT TECH BULLETINS!

 

NOTE: Installation Limitation

- IP1 is a passive device so there is a transformer inside only, like a CCTV balun.

It mixes the four conductors of CAT5e cable ( TX+, TX-, RX+, RX- ) to one coaxial cable (copper wire and copper mesh total of two conductors)

In good condition all sets of IP1 and cameras are online normally, the quantity limitation depends on the bandwidth of Ethernet.

You could use 2, 4, 8, or more IP1 without any problems.

But if any of the camera sites is missing or disconnected, the four signals ( TX+, TX-, RX+, RX- ) may return to the Ethernet switch and cause a loop (broadcasting storm)

You can fix the problem by removing the IP1 from the Ethernet switch until camera issue is resolved. If your budget allows please use Model:IP9CK

 

DOCUMENTATION

IP1 Instructions